Jenn-Air LI3UUB User Manual download pdf (Page 5)

Parts needed

For vented installations, you will also need:

■ 1 wall or roof cap

■ Metal vent system

For non-vented (recirculating) installations, you will also

need:

■ Recirculation Kit Part Number W10272063 for non-vented

(recirculating) installations only. See “Assistance or Service”

section to order.

■ 6" (15.2 cm) dia. round metal vent duct - length required is

determined by ceiling height.

Parts supplied

Remove parts from packages. Check that all parts are included.

■ Hood canopy assembly with ventilator and light bulbs

installed

■ Vent transition with back draft dampers installed

■ Metal grease filter(s)

■ Vent cover support bracket

■ Mounting template

■ 2-piece vent cover

■ 2 - 3.5 x 6.5 mm screws

■ 2 - 2.9 x 6.5 mm screws

■ 6 - 5 x 45 mm mounting screws

■ 2 - 8 x 40 mm wall anchors

■ 4 - 10 x 50 mm wall anchors

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Have a qualified technician install the range hood. It is the

installer's responsibility to comply with installation clearances

specified on the model/serial rating plate. The model/serial rating

plate is located behind the left filter on the rear wall of the vent

hood.

Canopy hood location should be away from strong draft areas,

such as windows, doors and strong heating vents.

Cabinet opening dimensions that are shown must be used. Given

dimensions provide minimum clearance.

Grounded electrical outlet is required. See “Electrical

Requirements” section.

The canopy hood is factory set for venting through the roof or

wall. For non-vented (recirculating) Installation see “For Non-

vented (recirculating) Installations Only” in “Connect Vent

System” section. Recirculation Kit Part Number W10272063 is

available from your dealer or an authorized parts distributor.

All openings in ceiling and wall where canopy hood will be

installed must be sealed.

For Mobile Home Installations

The installation of this range hood must conform to the

Manufactured Home Construction Safety Standards, Title 24

CFR, Part 328 (formerly the Federal Standard for Mobile Home

Construction and Safety, Title 24, HUD, Part 280) or when such

standard is not applicable, the standard for Manufactured Home

Installation 1982 (Manufactured Home Sites, Communities and

Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local

codes.

Product Dimensions

*For non-vented (recirculating) installations

**For vented installations

Cabinet Dimensions

*For non-vented (recirculating) installations

*NOTE: The range hood chimneys are adjustable and designed

to meet varying ceiling or soffit heights depending on the

distance “X” between the bottom of the range hood and the

cooking surface. For higher ceilings, a Stainless Steel Chimney

Extension Kit Part Number W10272070 is available from your

dealer or an authorized parts distributor. The chimney extension

replaces the upper chimney shipped with the range hood.

IMPORTANT:

Minimum distance "X": 27" (68.6 cm) from electric cooking

surface.

Minimum distance "X": 30" (76.2 cm) from gas cooking

surfaces.

Suggested maximum distance "X": 36" (91.4 cm)

For vented installations, the chimneys can be adjusted for

ceilings between 7’ 11" (2.4 m) and 8' 8" (2.6 m).

For non-vented (recirculating) installations, the chimneys can

be adjusted for ceilings between 7’ 11" (2.4 m) and 9' 0" (2.7 m).

36" (91.4 cm)

10¹⁄₈"

(25.8 cm)

20" (50.8 cm)

14¹⁄₈"

(35.9 cm)

*28¹⁵⁄₁₆" (73.4 cm) min.

42³⁄₁₆" (107.2 cm) max.

**28⁷⁄₈" (73.3 cm) min.

38⁷⁄₁₆" (97.6 cm) max.

8¹⁄₁₆"

(20.4 cm)

8¹⁄₈"

(20.7 cm)

¹⁄₄" (18.4 cm)

6⁵⁄₈" (16.8 cm)

2" (5.1 cm) min.

6" (15.2 cm) min.*

Centerline

Side

cabinet

Side

cabinet

Vent and power

supply cable

entry location

Cooking surface

36" (91.4 cm)

15" (38.1 cm)

7³⁄₈" (18.8 cm)

"X"

bottom of

canopy

to cooking

surface

1 2 3 4 5 6 7 8 9 10 ... 31 32

Comments to this Manuals

No comments

Jenn-Air LI3UUB User Manual Page 5

Comments to this Manuals

Related products and manuals for Cooker hoods Jenn-Air LI3UUB