Jenn-air JGD8348CDP User Manual download pdf (Page 9)

INCHES

BURNER BTU/hr ORIFICE DIAMETER COLOR

Left Rear (LR) 8,000 #55 .0520 Green

Left Front (LF) 8,000 #55 .0520 Green

Center Rear (CR) 10,000 #53 .0595 Brass

Center Front (CF) 10,000 #53 .0595 Brass

Right Rear (RR) 10,000 #53 .0595 Brass

Right Front (RF) 10,000 #53 .0595 Brass

TO CONVERT APPLIANCE FOR USE WITH NATURAL GAS

Natural Gas conversion is to be performed by a

Jenn-Air Authorized Service Contractor (or

other qualified agency) in accordance with the

manufacturer’s instructions and all codes and

requirements of the authority having

jurisdiction. Failure to follow instructions could

result in serious injury or property damage. The

qualified agency performing this work assumes

responsibility for this conversion.

WARNING

ELECTRICAL POWER AND GAS MUST BE

TURNED OFF PRIOR TO CONVERSION

WARNING

Propane Gas (LP) To Natural Gas

Conversion Instructions

If this appliance has been converted for use with LP Gas,

each of the following modifications must be performed to

convert the unit back to Natural Gas.

Model - JGD8348CDP

Manifold - Natural Gas pressure required - 5² W.C.

Incoming Natural Gas pressure required to appliance

pressure regulator - 6² -7² W.C.

Natural Gas input specified - 56,000 BTU/hr.

A. Replace all orifice hoods - Perform steps 1 through 4 on

page 7. Locate the (6) six Natural Gas hoods (withsmall

numbers stamped on their sides saved from the original

Natural Gas unit). Page 5 Illustration “E”. The two

hoods with .0520 (#55 orifice) stamped on them are for

the left front and left rear burners. The four hoods with

the .0595 (#53 orifice) stamped on them are for the two

right burners.

To make these conversion adjustments follow the

instructionsand illustrations (“A” through “E”) pages

5-7.

B. Invert cap in appliance pressure regulator (see

Illustration “D”, page 6). With the appliance installed,

the appliance pressure regulator is located on the right

underside of the appliance at the inlet to the gas

manifold. Identify the type of appliance pressure

regulator on the unit and follow the instructions in the

appropriate illustration.

C. Adjust low flame setting for each burner. Follow the

instructions for burner low flame adjustment on page 7

to increase the simmer flame size.

JGD8348CDP

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comments to this Manuals

No comments

Jenn-air JGD8348CDP User Manual Page 9

Comments to this Manuals

Related products and manuals for Fans Jenn-air JGD8348CDP