Jenn-Air JBFFS42NHP Installation Manual download pdf (Page 11)

INSTALLATION | 11

INSTALLATION

INSTALLING GRILLE BRACKET ASSEMBLY

APPLIES TO:

NOTE: If refrigerator is not on rollers, it is

recommended to lower the product to have more

access at the top of product for panel installation. For

ease of grille installation, it is recommended to have

product outside of kitchen cabinet not more than 8"

(20.32 cm).

1. Remove the three screws fastening each

mounting plate to the top of the refrigerator on

each side. Discard the mounting plates but keep

the screws for attaching the two grille bracket

assemblies provided in this kit.

2. Remove the two screws fastening the air divider

to the unit housing. Discard the air divider, and

reinstall the screws into the holes from where

they were removed.

3. Align the three holes in a grille bracket assembly

with the three holes in a cabinet side, as shown.

Using the screws removed in Step 1, attach the

grille bracket assembly.

4. Repeat step 3 to install the other grille bracket

assembly to the opposite side of the refrigerator.

IMPORTANT: Installing the full height door

panels before removing both existing factory

installed grille brackets can damage the panels.

WARNING

Excessive Weight Hazard

Use two or more people to move and install

refrigerator.

Failure to do so can result in back or other

injury.

Parts to be used:

X2 Grille bracket assembly

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 50 51

No comments

Jenn-Air JBFFS42NHP Installation Manual Page 11