Jenn-Air JES1450FB Installation Manual download pdf (Page 12)

4. Use a Phillips screwdriver to connect the green ground wire

from the power supply cord to the range with the ground-link

screw and ground-link section. The ground wire must be

attached over the ground-link section.

5. Use ³⁄₈" (1.0 cm) nut driver to connect the neutral (white) wire

to the center terminal block post with one of the 10-32 hex

nuts.

6. Connect line 2 (red) and line 1 (black) wires to the outer

terminal block posts with 10-32 hex nuts.

7. Firmly tighten hex nuts.

NOTE: For power supply cord replacement, use only a power

cord rated at 250 volts minimum, 40- or 50-amps that is

marked for use with nominal 1³⁄₈" (3.5 cm) diameter

connection opening, with ring terminals and marked for use

with ranges.

8. Tighten strain relief screws.

IMPORTANT: Verify the tightness of the hex nuts.

9. Replace lower access cover.

Install Using Direct Wire

Direct Wire Strain Relief

1. Disconnect power.

2. Remove the lower access cover screws located on the back

of the range. Pull the bottom of the cover toward you and out

to remove cover from range.

3. Remove plastic tag holding three 10-32 hex nuts from the

middle post of the terminal block.

A. 10–32 hex nut

B. Ground-link screw

C. Line 2 (red) wire

D. Green ground wire

E. Neutral (white) wire

F. Line 1 (black) wire

A. Mounting tabs (3)

B. Lower access cover

C. Screws (2)

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Use 8 gauge copper or 6 gauge aluminum wire.

Electrically ground range.

Failure to follow these instructions can result in death,

fire, or electrical shock.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Jenn-Air JES1450FB Installation Manual Page 12