Jenn-Air W10439669A User Manual download pdf (Page 5)

For a 36" (91.4 cm) base cabinet: The poster board template

will be located closer to the center of the cabinet. Note the area

to be cut out of the cabinet floor is in the toe-kick area.

Top View of Cabinet

NOTE: For illustration purposes, the cabinet front is not shown in

most of the following illustrations.

IMPORTANT: Do not cut the cabinet front.

Cutout Steps

1. Use the framing square and draw a line on the cabinet floor

parallel to the edge of the blower exhaust scroll.

Top View of Cabinet

2. Flip the framing square over and slide it against the cabinet

front.

3. Extend the line made in Step 1 to the cabinet front.

NOTE: For clarity, the cabinet front is not shown in this view.

4. Locate template included with the installation kit.

5. Center the line made in Step 3 within the alignment notch of

the template. Make sure the edge of the template is against

the cabinet front.

6. Tape template to bottom of cabinet with masking tape as

shown in the following illustrations.

30" (76.2 cm) Base Cabinet Template Position

Top View of Cabinet

A. Front of cabinet

B. Area to be cut out

C. Toe kick

D. Template

E. Left side of cabinet

A. Blower exhaust scroll

B. Framing square

C. Cabinet floor

A. Pilot hole locations

B. Alignment notch

A. Left side of cabinet

B. Toe-kick area

C. Area to be cut out

D. Cabinet front

E. Center mullion

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Jenn-Air W10439669A User Manual Page 5