Jenn-Air JGD3430GS Installation Manual download pdf (Page 10)

INSTALLATION INSTRUCTIONS

Prepare Cooktop

Decide on the ﬁnal location for the cooktop.

IMPORTANT: Do not cut top of product packaging. This may

damage the product.

1. Open product as instructed on product packaging.

2. Remove all items from both sides of the foam and set aside.

Take out packaging foam and set aside to lay cooktop on.

IMPORTANT: Do not place packaging foam on knobs.

3. Using 2 or more people, remove cooktop and place the

cooktop upside down on the packaging foam, making sure

the knobs are not laid on the foam.

4. Remove plenum and plenum screw pack (in the literature

bag).

5. Remove downdraft motor assembly.

6. Place plenum on bottom of cooktop with round opening

to the motor wire harness.

NOTE: All holes are pre-drilled. If all 6 holes do not line up,

reverse plenum.

7. Using a

" nut driver, screw in the 6 screws from the

literature pack to attach plenum.

8. Remove access panel from plenum using a

" nut driver

and set aside.

9. Remove 4 locking nuts and 4 washers from literature bag.

NOTE: Remove the 4 protective caps from the motor

mounting posts.

10. Place blower motor on plenum.

11. Install and ﬁnger-tighten the 4 washers and locking nuts that

were removed through the opening of the motor access

panel. Do not over-tighten to allow for motor to rotate.

12. Connect blower electrical connector to cooktop.

WARNING

Excessive Weight Hazard

Use two or more people to move and install cooktop.

Failure to do so can result in back or other injury.

A. Plenum

B. Cooktop

C. Motor wire harness

A. Access panel

B. 2 screws

A. Blower motor

B. Plenum

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Comments to this Manuals

No comments

Jenn-Air JGD3430GS Installation Manual Page 10

Comments to this Manuals

Related products and manuals for Unknown Jenn-Air JGD3430GS