Jenn-Air JGD3430GS Installation Manual download pdf (Page 8)

Calculating Vent System Length

To calculate the length of the system you need, add the

equivalent feet (meters) for each vent piece used in the system.

Vent Piece 6" (15.2 cm) Round

45° elbow 2.5 ft

(0.8 m)

90° elbow 5.0 ft

(1.5 m)

6" (15.2 cm) wall cap 0.0 ft

(0.0 m)

" x 10" (8.3 cm x 25.4 cm)

to 6" (15.2 cm) transition

4.5 ft

(1.4 m)

6" (15.2 cm) to 3

" x 10"

(8.3 cm x 25.4 cm) transition

1 ft

(0.3 m)

" x 10" (8.3 cm x 25.4 cm)

to 6" (15.2 cm) 90° elbow

transition

5.0 ft

(1.5 m)

6" (15.2 cm) to 3

" x 10"

(8.3 cm x 25.4 cm) 90° elbow

transition

5.0 ft

(1.5 m)

" x 10" (8.3 cm x 25.4 cm)

90° elbow

5.0 ft

(1.5 m)

" x 10" (8.3 cm x 25.4 cm)

ﬂat elbow

12.0 ft

(3.7 m)

" x 10" (8.3 cm x 25.4 cm)

wall cap

0.0 ft

(0.0 m)

Example vent system

1- 90° elbow = 5 ft (1.5 m)

8 ft (2.4 m) straight = 8 ft (2.4 m)

1 - wall cap = 0 ft (0 m)

System length = 13 ft (3.9 m)

NOTE: Flexible vent is not recommended. Flexible vent

creates back pressure and air turbulence that greatly reduce

performance.

Electrical Requirements

IMPORTANT: The cooktop must be electrically grounded in

accordance with local codes and ordinances, or in the absence

of local codes, with the National Electrical Code, ANSI/NFPA 70

or Canadian Electrical Code, CSA C22.1.

This cooktop is equipped with an electronic ignition system

that will not operate if plugged into an outlet that is not properly

polarized.

If codes permit and a separate ground wire is used, it is

recommended that a qualiﬁed electrical installer determine

that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, Ohio 44131-5575

■ A 120-volt, 60 Hz, AC-only, 15-amp, fused electrical circuit

is required. A time-delay fuse or circuit breaker is also

recommended. It is recommended that a separate circuit

serving only this cooktop be provided.

■ Electronic ignition systems operate within wide voltage limits,

but proper grounding and polarity are necessary. Check that

the outlet provides 120-volt power and is correctly grounded.

■ The wiring diagrams are provided with this cooktop. See

“Wiring Diagrams” on a separate sheet. The wiring diagrams

are located on the underside of the cooktop base.

■ This gas cooktop is not required to be plugged into a GFCI-

(Ground-Fault Circuit Interrupter) outlet or AFCI- (Arc Fault

Circuit Interrupter) type circuit breaker. It is recommended

that you not plug an electric spark ignition gas cooktop or

any other major appliance into a GFCI wall outlet or an AFCI-

type circuit breaker as it may cause these types of circuit

breakers to trip during normal cycling.

■ Performance of this cooktop will not be affected if operated

on a GFCI/AFCI-protected circuit. However, occasional

nuisance tripping of the GFCI breaker is possible due to the

normal operating nature of electronic gas cooktops.

90˚ elbow

2 ft

(0.6 m)

6 ft (1.8 m)

wall cap

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments

Jenn-Air JGD3430GS Installation Manual Page 8

Comments to this Manuals

Related products and manuals for Unknown Jenn-Air JGD3430GS