Jenn-Air JWD3030EX Installation Manual download pdf (Page 7)

7. Use the two #8-18 x

" screws provided to secure the

warming drawer frame to the cabinet.

Complete Installation

1. Check that all parts are now installed. If there is an extra

part, go back through the steps to see which step was

skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. For warming drawer use and cleaning, read the Use

and Care Guide.

5. Push in and turn the control knob to HI, and the light

should illuminate.

If warming drawer(s) does not operate, check

the following:

■ Household fuse is intact and tight, or circuit breaker

has not tripped.

■ Warming drawer is plugged in, and electrical supply

is connected.

If you need Assistance or Service:

Please reference the “Warranty” section of the Use and

Care Guide.

CUSTOM DRAWER FRONT INSTALLATION INSTRUCTIONS

FOR WARMING DRAWERS

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools Needed

■ Phillips screwdriver

■ Drill and appropriate bits

Parts Supplied

■ #8-18 x

" screws (6)

■ Indicator light lens

Parts Needed

■ Custom drawer front

■ Custom handle (optional)

■ Adhesive recommended for plastic to wood

Install Custom Drawer Front Panel

The warming drawer has an interface that will allow a modest

range of panel sizes. The actual panel size should be selected

by the customer and the contractor to suit the desired effect.

It is recommended that a qualiﬁed carpenter make and install

the custom drawer front and handle(s) to match surrounding

cabinetry.

1. Install warming drawer unit as instructed by the Installation

Instructions provided with the warming drawer.

2. Create the custom drawer front. Below are the minimum and

maximum dimensions for the custom drawer front. The size

of the custom drawer front for the warming drawer will vary

according to the speciﬁc installation. The depth of the panel

will vary in order to have the custom warming drawer ﬂush

with the surrounding cabinets.

A. Two #8-18 x

" screws

⁵⁄₁₆" (7.9 mm) dia. hole for

indicator light lens (provided

in this kit). Locate lens directly

in front of indicator light.

Model A - MAX B - MAX A - MIN B - MIN

24" (60.9 cm)

Warming

Drawer

(60.3 cm)

(26.2 cm)

23"

(58.4 cm)

(23.0 cm)

27" (68.6 cm)

Warming

Drawer

(67.9 cm)

(26.2 cm)

26"

(66.1 cm)

(23.0 cm)

30" (76.2 cm)

Warming

Drawer

(75.6 cm)

(26.2 cm)

29"

(73.7 cm)

(23.0 cm)

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Jenn-Air JWD3030EX Installation Manual Page 7

Comments to this Manuals

Related products and manuals for Unknown Jenn-Air JWD3030EX