Jenn-Air JJW2830DB Installation Guide download pdf (Page 8)

3. At a 45° angle, align door hinges with slots in the lower

front of the oven cavity. Slowly insert door, making sure

you maintain the 45° angle. You will know the door is

engaged in the slot when you feel a slight drop.

4. Lower the oven door to the fully open position. If the oven

door does not open to a full 90°, repeat steps 1 through 3.

5. Locate the oven door hinge locks in the corners of the

oven door, and rotate the hinge locks toward the oven

cavity to the locked position.

See Step 3 (illustration A) in the “Remove Oven Door(s)”

section for proper locked position.

6. Close the oven door.

7. When the hinges are properly installed and the door closed,

there should be an even gap between the door and the

control panel. If one side of the oven door is hanging lower

than the other, the hinge on that side is not properly installed.

Positioning Oven Feet for Multiple

Cabinet Cutout Heights

Single Ovens

The positioning of the oven feet allow a single oven to

be installed in a cutout height between 26¹⁵⁄₁₆" and 29⁷⁄₁₆"

(68.4 cm and 74.8 cm). Refer to the following instructions

to position the feet for the size of your cabinet cutout.

Cutout Height Is Between 27⁵⁄₈" and 28⁵⁄₈"

(70.2 cm and 72.7 cm)

The oven feet do not need to be changed. They

are positioned correctly as received.

Go to the “Make Electrical Connection” section.

Cutout Height Is Between 26¹⁵⁄₁₆" and 27¹¹⁄₁₆"

(68.4 cm and 70.3 cm)

1. Using 2 or more people, place the oven on its back

on a covered surface.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

Jenn-Air JJW2830DB Installation Guide Page 8