Jenn-Air JVD0303GS Installation Manual download pdf (Page 4)

Electrical Requirements

IMPORTANT: The downdraft vent must be electrically grounded

in accordance with local codes and ordinances, or in the

absence of local codes, with the National Electrical Code, ANSI/

NFPA 70 or Canadian Electrical Code, CSA C22.1.

This downdraft is equipped with an electronic touch pad system

that will not operate if plugged into an outlet that is not properly

polarized.

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

WARNING

If codes permit and a separate ground wire is used, it is

recommended that a qualied electrical installer determine that

the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

■ A 120-volt, 60 Hz., AC-only, 15-amp fused, electrical circuit

is required. A time-delay fuse or circuit breaker is also

recommended. It is recommended that a separate circuit

serving only this downdraft vent be provided.

■ Electronic touch pad systems operate within wide voltage

limits, but proper grounding and polarity are necessary.

Check that the outlet provides 120-volt power and is

correctly grounded and polarized.

■ The wiring diagram is provided with this downdraft vent. See

the “Wiring Diagram” section.

■ Downdraft must have a dedicated electrical receptacle and

power supply.

1 2 3 4 5 6 7 8 9 ... 14 15

No comments

Jenn-Air JVD0303GS Installation Manual Page 4