Jenn-Air JDB9600CWS Installation Manual download pdf (Page 7)

After locating the proper place for your new dishwasher, you

will need to create any required openings to allow for passage

of the water, drain and electrical line. In order to avoid inter-

ference with the dishwasher when sliding it into the cabinet,

place your openings within the dimensions shown in Figure 3.

Required Openings:

3/4

" x 2

3/8

" (120 x 60 mm) - To pass the included electrical

supply junction box through to adjacent cabinet.

Note: If the incoming electric supply, water supply and drain

connections are all in the same cabinet, the one 4

3/4

" x 2

3/8

(120 x 60 mm) hole will be large enough for all three to pass

through.

4" x 2" (100 x 50 mm) - To pass the included water supply line

toward the water supply

1/4

" (32 mm) diameter - To pass the dishwasher drain hose

toward the drain connection

Before sliding the dishwasher into the cabinet, remove the

hose clip at the back of the dishwasher as shown in Figure

4. The hose clip may be used later to hold the drain hose as

shown in Figure 10.

In select models, remove the rubber apron on top of the dish-

washer and set aside for later use. See Figure 5.

NOTE: This dishwasher is designed to be enclosed on the

top and both sides by standard residential kitchen cabinetry.

Select a location as close to the sink as possible for easy ac-

cess to water supply and drain lines. For proper dishwasher

operation and appearance, ensure that the enclosure is

square and has the dimensions shown in Figure 1.

NOTE: If your dishwasher opening width measures

>23

5/8

" (600 mm), use the TOP or SIDE MOUNT mounting

methods.

If your dishwasher opening width measures 23

5/8

" (600

mm), use the ALTERNATE SIDE MOUNT mounting

method.

If the dishwasher is to be installed in a corner, make sure that

there is adequate clearance to open the door. See Figure 2.

Enclosure Requirements

WARNING

90°

(575mm)

óƎ(867mm)

- 24

Ǝ

(600 - 616mm)

(114mm)

(64mm)

Check clearance

between

dishwasher door

and wall

Countertop

Avoid Scalding or Electrical Shock Hazard!

Make sure the water supply and electrical supply are

shut off before installation or service.

Avoid Electrical Shock/Fire Hazard!

Do not allow the electrical and water supply lines to

touch.

Figure 5

Figure 4

Figure 3

Figure 1

Figure 2

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

Jenn-Air JDB9600CWS Installation Manual Page 7

Comments to this Manuals

Related products and manuals for Unknown Jenn-Air JDB9600CWS