Jenn-Air JDB9600CWS Installation Manual download pdf (Page 9)

Method B - To permanently connect to household

RUƗHOGZLULQJ

1. Remove the dishwasher electrical supply junction box

cover and connect to the power supply cord from the

house installation. See Figure 7.

2. Remove 2" to 3" (51 - 76 mm) of the outer casing of the

KRXVHKROGRUƖHOGVXSSO\ZLULQJDVVKRZQLQFigure 8.

Remove 3/8" to 1/2" (10 - 13 mm) of the insulation from

each wire as shown in Figure 8.

3. Insert the bare copper or green wire (ground) to the “G”

ground connection “ ” of the terminal block and se-

curely tighten the terminal block screw (see Figure 7).

4. Insert the white (neutral) wire to the “N” connection of

the terminal block and securely tighten the terminal block

screw.

5. Insert the black (hot) wire to the “L” connection of the ter-

minal block and securely tighten the terminal block screw.

6. Check all electrical connections to make sure they are

secure and then attach the junction box cover with the

4 screws.

Hot Water Supply

The hot water heater should be set to deliver approximately

120° F (49° C) water to the dishwasher. Water that is too hot

can cause some detergents to lose effectiveness. Lower water

temperatures will increase run times. The hot water supply

pressure must be between 15 - 145 psi (1 - 10 bar).

IMPORTANT NOTES:

• ,IXVLQJDVROGHUMRLQWLQVWHDGRIDFRPSUHVVLRQƖWWLQJEH

sure to make all solder connections before connecting

the water supply line to the dishwasher.

• Make sure there are no sharp bends or kinks in the water

line that might restrict water low.

• Always use the appropriate seal when making plumbing

connections.

• Before connecting the water supply line to the dishwasher,

lush the incoming water line for approximately 5 minutes

to clear any foreign material.

• Turn on the water supply and check for leaks after con-

nections are made.

Water Supply Shut Off Valve

Install an easily accessible shut-off valve (not supplied)

in the hot water supply line, as shown in Figure 9. All

solder connections must be made before the water line

is connected to the dishwasher.

3/8" - 1/2"

(10mm - 13mm)

2" - 3"

(51mm - 76mm)

WARNING

CAUTION

Avoid Scald Hazard

Do not perform any work on a charged hot water line.

6HULRXVLQMXU\FRXOGUHVXOW2QO\TXDOLƖHGSOXPEHUV

should perform plumbing work. Do not attempt any

work on the dishwasher hot water supply plumbing

until you are certain the hot water supply is shut off.

Temperatures required for soldering and sweating will

damage the dishwasher. If plumbing lines are to be

soldered or sweated, keep the heat source at least 6

inches (152.4 mm) away from the dishwasher.

Inlet Water Connections

Figure 8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Jenn-Air JDB9600CWS Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Unknown Jenn-Air JDB9600CWS