Jenn-Air JJW2830DB Installation Guide download pdf (Page 15)

5. The bottom vent and bottom vent trim (required when

the oven is installed with the feet in the tall position)

are shipped in the foam packing at the top of the oven.

To install only the bottom vent, see the following instructions.

To install both the bottom vent and the bottom vent trim

for installations with the feet in the tall position, see

the instructions in Step 6.

■ Align vent tab (B) with oven frame (A) as shown.

■ Using one #8-18 x ³⁄₈" screw (D) on each side of

the vent tab (B), fasten the vent securely to the oven.

6. On models with the feet installed in the tall position,

the bottom vent trim must also be installed. See the

following instructions to install.

■ Flex the upper vent piece (C) away from the lower vent

piece (D) to slide the bottom vent trim (B) between them.

Some force may be required to flex the upper vent trim (C)

away from the lower vent trim (D). Some force may also

be required to flex the bottom vent trim (B) and slide it

into position. Make sure screw holes are properly aligned

between the two pieces. See the following illustration.

■ Install the bottom vent trim (B) to the lower vent piece

(D) using two #8-18 x

¹⁄₄" screws on each side.

NOTE: On 27" (68.6 cm) models, only one #8-18 x

¹⁄₄"

screw is used on each side.

■ Align vent tab (B) with oven frame (A) as shown.

■ Using one #8-18 x ³⁄₈" screw (E) on each side of

the vent tab (B), fasten the vent securely to the oven.

7. Replace the oven racks.

8. Replace the oven door. See the “Replace

Oven Door(s)” section.

9. Check that the door is free to open and close. If it is

not, repeat the removal and installation procedures.

See the “Prepare Built-In Oven” section.

10. Repeat for lower oven door.

11. Reconnect power.

12. The display panel will light briefly, and “PF” should appear

in the display.

13. If the display panel does not light, reference the “Warranty”

section of the Use and Care Guide.

Install Warming Drawer Deflector Kit

(Only for Ovens Installed above

Warming Drawers)

On single and double oven models installed above a warming

drawer, a warming drawer deflector kit must be installed. See

the “Tools and Parts” section for information on ordering.

Parts Supplied in Deflector Kit

A. Oven frame

B. Vent tab

C. Oven vent

D. #8-18 x

³⁄₈

" screws

A. #8-18 x

¹⁄₄

" screw

B. Bottom vent trim

C. Upper vent piece

D. Lower vent piece

A. Oven frame

B. Vent tab

C. Oven vent

D. Bottom vent trim

E. #8-18 x

³⁄₈

" screw

A. Phillips head screws (4)

only 2 screws for 27" (68.6 cm) size

B. Warming drawer deflector (1)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Jenn-Air JJW2830DB Installation Guide Page 15

Comments to this Manuals

Related products and manuals for Unknown Jenn-Air JJW2830DB