Jenn-Air JDRP536WP Installation Manual download pdf (Page 15)

3. Attach one adapter to the gas pressure regulator and

the other adapter to the gas shut-off valve. Tighten both

adapters, being certain not to move or turn the gas

pressure regulator.

4. Use a

" combination wrench and an adjustable wrench

to attach the ﬂexible gas supply to the adapters. Check that

connector is not kinked.

IMPORTANT: All connections must be wrench-tightened. Do

not make connections to the gas regulator too tight. Making

the connections too tight may crack the regulator and cause

a gas leak. Do not allow the regulator to turn or move when

tightening ﬁttings.

Complete Connection

1. Open the manual shut-off valve in the gas supply line. The

valve is open when the handle is parallel to the gas pipe.

2. Test all connections by brushing on an approved

noncorrosive leak-detection solution. If bubbles appear,

a leak is indicated. Correct any leak found.

3. Remove cooktop burner caps, burner bases, and grates from

parts package. Place burner bases on cooktop and burner

caps on burner bases. Place grates over burners and caps.

4. Check that the range is plugged into the appropriate

grounded outlet. (See the “Electrical Requirements” section.)

5. Turn on power supply. For further information, please refer

to the user instructions located in the Use and Care Guide.

Verify Anti-Tip Bracket Location

1. Using a

" socket or wrench, turn all 4 leveling rods one full

turn to raise the range and provide enough clearance for the

rear leveling leg to slide into the anti-tip bracket.

2. Move range into its ﬁnal location, making sure rear leveling

leg slides into anti-tip bracket.

3. Use a ﬂashlight to look underneath the bottom of the range

and visually check that the rear range foot is inserted into

the slot of the anti-tip bracket.

Level Range

NOTE: Range must be level for satisfactory baking performance.

1. Place rack in oven.

2. Place level on rack and check levelness of the range –

ﬁrst side to side, then front to back.

3. If range is not level, adjust the leveling rods. Turn leveling

rods located behind the kick plate to level range and to

raise or lower range to the desired countertop height.

NOTE: All roller feet must be off the ﬂoor upon ﬁnal installation.

Install Griddle

(on griddle models)

The griddle is factory installed.

1. Place drip tray in the well at the front of the griddle.

Slide tray toward the back until it stops.

2. Clean griddle before using. Refer to the Use and Care Guide.

A. Gas pressure regulator

B. Use pipe-joint compound.

C. Adapter (must have

male pipe thread)

D. Flexible connector

E. Manual gas shut-off valve

" or

" gas pipe

G. Use pipe-joint compound.

H. Adapter

A. Closed valve

B. Open valve

A. Rear leveling rod

B. Front and brass leveling rod

A. Griddle drip tray

B. Griddle

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Comments to this Manuals

No comments

Jenn-Air JDRP536WP Installation Manual Page 15

Comments to this Manuals

Related products and manuals for Cookers Jenn-Air JDRP536WP