Jenn-Air JDRP536WP Installation Manual download pdf (Page 9)

Electrical Requirements –

Canada Only

If codes permit and a separate ground wire is used, it is

recommended that a qualiﬁed electrical installer determine

that the ground path and wire gauge are in accordance with

local codes.

Be sure that the electrical connection and wire size are adequate

and in conformance with the CSA Standard C22.1, Canadian

Electrical Code, Part 1 - latest edition, and all local codes and

ordinances.

A copy of the above code standards can be obtained from:

Canadian Standards Association

178 Rexdale Blvd.

Toronto, ON M9W 1R3 CANADA

■ Check with a qualiﬁed electrical installer if you are not sure

the range is properly grounded.

■ When a 4-wire, single-phase 250-volt, 60 Hz., AC-only

electrical supply is available, a 40-amp minimum circuit

protection is required on 30" (76.2 cm) and 36" (91.4 cm)

ranges and a 50-amp minimum circuit protections is required

on 48" (121.9 cm) ranges, fused on both sides of the line.

■ A time-delay fuse or circuit breaker is recommended.

■ This range is equipped with a CSA International Certiﬁed

Power Cord intended to be plugged into a standard 14-50R

wall receptacle. Be sure the wall receptacle is within reach

of range’s ﬁnal location.

■ Do not use an extension cord.

Gas Supply Requirements

Observe all governing codes and ordinances.

IMPORTANT: This installation must conform with all local codes

and ordinances. In the absence of local codes, installation must

conform with American National Standard, National Fuel Gas

Code ANSI Z223.1/NFPA 54 - latest edition or CAN/CGA B149 -

latest edition.

IMPORTANT: Range cooktop must be connected to a regulated

gas supply.

IMPORTANT: Leak testing of the range cooktop must be

conducted according to the manufacturer’s instructions.

Type of Gas

Natural Gas:

This range is factory set for use with Natural gas. The model/

serial/rating plate, located under the console on the right-hand

side, has information on the types of gas that can be used. If

the types of gas listed do not include the type of gas available,

check with the local gas supplier.

LP Gas Conversion:

Conversion must be done by a qualiﬁed service technician.

No attempt shall be made to convert the range cooktop from

the gas speciﬁed on the model/serial/rating plate for use with

a different gas without consulting the serving gas supplier. To

convert to LP gas, use the LP gas conversion kit provided with

your range and see the “Gas Conversions” section. The parts for

this kit are in the literature package supplied with the range.

WARNING

Electrical Shock Hazard

Electrically ground range.

Failure to do so can result in death, fire, or

electrical shock.

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure

gas pressure does not exceed 14" (36 cm) water

column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and

authorized service personnel.

Failure to do so can result in death, explosion, or fire.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comments to this Manuals

No comments

Jenn-Air JDRP536WP Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Cookers Jenn-Air JDRP536WP