Jenn-air air filter User Manual download pdf (Page 5)

Jenn-Air’s ventilation system is designed to capture both

cooking fumes and smoke from the cooktop surface. If the

system does not, here are some ducting installation situations

to check:

• 6” diameter round or 3

” x 10” rectangular ducting should

be used for duct lengths 10’-60’.

• There should be a minimum clearance of 6” for cooktop

installed near a side wall.

If there is not an obvious improper installation, there may be a

concealed problem such as a pinched joint, obstruction in the

pipe, etc. Installation is the responsibility of the

installer and questions should be addressed

first by the installer. The installer should very

carefully check the ducting installation instruc-

tions.

• Use the Flow Tester Card provided with your

appliance to check the air flow.

DUCTING INFORMATION

• No more than three 90° elbows should be used. Distance

between elbows should be at least 18”.

• Recommended Jenn-Air wall cap MUST be used. Make

sure damper moves freely when ventilation system is

operating.

Important: 5” diameter round ducting may be used if the

duct length is 10’ or less.

CARE & CLEANING

* Brand names for cleaning products are registered trademarks of the respective manufacturers.

Self-Clean Oven

CAUTION

• It is normal for parts of the oven to become hot during a

self-clean cycle.

• To prevent damage to oven door, do not attempt to open

the door when LOCK is displayed.

• Avoid touching door, window or oven vent area during a

clean cycle.

• Do not use commercial oven cleaners on the oven finish

or around any part of the oven. They will damage the

finish or parts.

The self-clean cycle uses above-normal cooking temperatures

to automatically clean the oven interior.

It is normal for flare-ups, smoking, or flaming to occur during

cleaning if the oven is heavily soiled. It is better to clean the

oven regularly rather than to wait until there is a heavy build-

up of soil in the oven.

During the cleaning process, the kitchen should be well

ventilated to get rid of normal odors associated with cleaning.

Before Self-Cleaning

easily after a self-clean cycle if they are not removed.

Important: Remove the air grille from the cooking surface

before self-cleaning.

3. Clean oven frame, door frame, area

outside of gasket, and around the

opening in the door gasket with a

nonabrasive cleaner such as Bon

Ami* or detergent and water. The

self-cleaning process does not

clean these areas. They should be

cleaned to prevent soil from baking on during the clean

cycle. (The gasket is the seal around the oven door and

window.)

4. To prevent damage, do not clean or rub the gasket around

the oven door. The gasket is designed to seal in heat

during the clean cycle.

5. Wipe up excess grease or spill-overs from the oven

bottom. This prevents excessive smoking, flare-ups or

flaming during the clean cycle.

6. Wipe up sugary and acidic spillovers such as sweet

potatoes, tomato, or milk-based sauces. Porcelain enamel

is acid-resistant, not acid-proof. The porcelain finish may

discolor if acidic or sugary spills are not wiped up before a

self-clean cycle.

Cont.

To set Self-Clean:

1. Press Clean pad.

2. REMOVE RACKS will be displayed. Remove the racks.

1. Turn off the oven light before cleaning. The oven light may

burn out during the clean cycle.

2. Remove broiler pan, all pans, and oven racks from the

oven. The oven racks will discolor and may not slide

8113P528-60 10/20/05, 11:56 AM5

1 2 3 4 5 6 7 8 9 10 ... 95 96

Comments to this Manuals

No comments

Jenn-air air filter User Manual Page 5

Comments to this Manuals